Xerox Phaser 3140 用户指南

Introduction_ 19

The color of the LEDs indicates the machine's current status.

Xerox does not recommend using non-genuine Xerox toner cartridge 

such as refilled or remanufactured. Xerox cannot guarantee 

non-genuine Xerox toner cartridge's quality. Service or repair required 

as a result of using non-genuine Xerox toner cartridges will not be 

covered under the machine warranty. 

If the problem persists, call for service.

 (Cancel button)

By pressing the 

 (cancel button), you can:

This button must be used to turn the machine on/off. When the machine is 

not in use, it will automatically enter power save mode. (See "Using power 

1. Plug in the power cord.
2. Press 

(power) on the control panel.

•

The cover is opened. Close the 

cover.

•

There is no paper in the tray. Load 

paper in the tray.

•

The machine has stopped due to a 

major error.

•

Your system has some problems. If 

this problem occurs, contact your 

service representative.

•

A toner cartridge has reached its 
estimated cartridge life

a

(See 

a.Estimated cartridge life means the expected or estimated toner 

cartridge life, which indicates the average capacity of print-outs and is 

designed pursuant to ISO/IEC 19752. The number of pages may be 

affected by operating environment, printing interval, media type, and 

media size. Some amount of toner may remain in the cartridge even 

when red LED turned on and the printer stops printing.

•

A minor error has occurred and the 

machine is waiting for the error to 

be cleared. When the problem is 

cleared, the machine resumes. 

•

Small amount of toner is left in the 

cartridge. The estimated cartridge 

life of toner is close. Order a new 

cartridge for replacement. You may 

temporarily increase the printing 

quality by redistributing the toner. 

A paper jam has occurred. 

(See "Clearing paper jams" on 

The machine is on-line and can 

receive data from the computer.

•

When the backlight slowly blinks, 

the machine is receiving data from 

the computer.

•

When the backlight blinks rapidly, 

the machine is printing data. 

a. When you print the demo page for Phaser 3140 and Phaser 3155, 

configuration information is included on the same page.

In Ready mode, press and hold this 

button for about 2 seconds until the status 

LED blinks slowly, and release. (See 

b. Phaser 3160B and Phaser 3160N only

In Ready mode, press and hold this 

button for about 

7 seconds until the status 

LED blinks fast, and release. (See 

"Printing a machine report" on page 50.)

In Ready mode, press and hold this 

button for about 10 seconds until the 

status LED blinks slow, and release. (See 

Press 

 (cancel button) during printing. 

The red LED blinks while the print job is 

cleared from both the machine and the 

computer and then the machine returns to 

ready mode. This may take some time 

depending on the size of the print job.

Press 

 (cancel button) each time you 

load a sheet of paper in the 
manual tray when you select Manual 

Feeder for Source from your software 

application.