Xerox Phaser 3140 用户指南

Troubleshooting_ 52

9.

troubleshooting

This chapter gives helpful information for what to do if you encounter an error.

•

•

•

•

•

  

When the toner cartridge is near the end of its life:

•

White streaks or light printing occurs. 

•

The 

 LED blinks red. 

If this happens, you can temporarily improve print quality by redistributing 

the remaining toner in the cartridge. In some cases, white streaks or light 

printing will still occur even after you have redistributed the toner.
1. Open the front cover.
2. Pull the toner cartridge out.

3. Thoroughly roll the cartridge five or six times to distribute the toner 

evenly inside the cartridge.

If toner gets on your clothing, wipe it off with a dry cloth and wash 

clothing in cold water. Hot water sets toner into fabric.

Do not touch the green underside of the toner cartridge. Use the 

handle on the cartridge to avoid touching this area. 

4. Hold the toner cartridge by the handle and slowly insert the cartridge into 

the opening in the machine. 
Tabs on the sides of the cartridge and corresponding grooves within the 

machine will guide the cartridge into the correct position until it locks into 

place completely.

5. Close the front cover. Ensure that the cover is securely closed. 

1. Open the rear cover.
2. Pull down the pressure lever on each side.

Keep the rear cover opened during printing. 
Only use when the printout has more than 20 mm curl.