Cisco Cisco Unified MeetingPlace Audio Server 维护手册
5-12
Cisco MeetingPlace Audio Server 5.2 Customer Engineering Guide (for Cisco MeetingPlace 8106)
78-16411-01
Chapter 5 Repairing and Maintaining the 8106 Server
Replacing the CPU
Removing the old CPU card
Step 1
Verify all steps in the
have been completed.
Step 2
Locate the CPU card in the CPU slot in the front of the server. See
Step 3
With a screwdriver, loosen the CPU card’s captive screws at the right and left of the panel. See
Step 4
Press the ejector levers outward. This partially unseats the CPU card from the backplane connectors. See
Step 5
Pull the CPU card out from the chassis by pressing the ejector levers outward and pulling the CPU card
out. See
out. See
.
Figure 5-10 Removing the CPU Card and Transition Module
Installing the new CPU card
Step 1
Press the ejector levers outward. See
Step 2
Holding the CPU card by the ejector levers, partially insert the CPU card into the slot, about half way.
Step 3
Verify that the CPU card is properly seated in the guides on the left and right sides. If not, remove the
CPU card and try again.
CPU card and try again.