Cisco Cisco Unified MeetingPlace Audio Server Maintenance Manual

5-12

Cisco MeetingPlace Audio Server 5.2 Customer Engineering Guide (for Cisco MeetingPlace 8106)

78-16411-01

Chapter 5 Repairing and Maintaining the 8106 Server

Replacing the CPU

Removing the old CPU card

Step 1

Verify all steps in the

have been completed.

Step 2

Locate the CPU card in the CPU slot in the front of the server. See

Step 3

With a screwdriver, loosen the CPU card’s captive screws at the right and left of the panel. See

Step 4

Press the ejector levers outward. This partially unseats the CPU card from the backplane connectors. See

Step 5

Pull the CPU card out from the chassis by pressing the ejector levers outward and pulling the CPU card
out. See

Figure 5-10 Removing the CPU Card and Transition Module

Installing the new CPU card

Step 1

Press the ejector levers outward. See

Step 2

Holding the CPU card by the ejector levers, partially insert the CPU card into the slot, about half way.

Step 3

Verify that the CPU card is properly seated in the guides on the left and right sides. If not, remove the
CPU card and try again.