Avaya 03-300430 User Manual

This test is destructive.
The Modem Pool Conference test checks most of the switching and gain control functions 
provided by the NPE circuit in the analog section of the conversion resource. This test 
conferences a 1004-Hz tone through the NPE, looping it back so that it can be verified with a 
Tone Detector circuit

ABRT

System resources required for this test are not available.

1000

ABRT

System resources required to run this test are not available. The port 
may be in use on a valid call. 

1. Determine whether the port is available for testing.

1002

ABRT

The system could not allocate time slots for the test. The system may be 
under heavy traffic conditions, or it may have time slots out-of-service 
due to TDM-BUS errors.

1. If the system has no TDM-BUS errors and is not handling heavy 

traffic, repeat test at 1-minute intervals up to 5 times.

1003

ABRT

The system could not allocate a tone receiver for the test. The system 
may be oversized for the number of Tone Detectors present, or some 
Tone Detectors may be out-of-service.

1. Resolve any TTR-LEV errors.

2. Resolve any TONE-PT errors.

3. If neither condition exists, retry the test at 1-minute intervals up to 5 

times.

1004

ABRT

The port has been seized by a user for a valid call. Determine whether 
the port is available for testing.

1. Retry the command at 1-minute intervals up to 5 times.

1020

ABRT

The test did not run due to a previously existing error on the specific port 
or because of a more general circuit pack error.

1. Examine the Error Log for existing errors against this port or the 

circuit pack, and attempt to diagnose previously existing errors.

 1 of 3