Avaya 03-300430 User Manual

This test updates the analog port’s message lamp state (if it has one) and translations with 
information in the software.

PASS

The port’s battery feed chip is able to provide sufficient power to the station 
equipment to detect on-/off-hook, but may not be able to supply power for 
touch-tones.

1. If touch-tones are inoperative on this station, replace the circuit pack or 

media module, because this port is inoperative.

2. Investigate user-reported troubles on this port by running other port 

tests, by examining station wiring, or by inspecting the station.

0

NO

BOARD

The test could not relate the internal ID to the port (no board).  This result 
could be due to incorrect translations, no board is inserted, an incorrect 
board is inserted, or an insane board is inserted.

1. Check to make sure that the board translations are correct.  Enter 

list configuration, and resolve any problems.

2. If the board is correctly inserted, enter busy board location
3. Enter reset board location
4. Enter release board location
5. Enter test board location long

This should re-establish the link between the internal ID and the port.  If not, 

verify that a valid board is inserted.

 3 of 3

ABRT

Necessary system resources could not be allocated to run this test.

1. Retry the command at 1-minute intervals up to 5 times.

2. If the test continues to abort, escalate the problem.

 1 of 3