Avaya 03-300430 User Manual

1000

ABRT

System resources required to run this test are not available.  The port may 
be busy with a valid call.

1. Use display port location  to determine the trunk group/

member number of the port.  Use status trunk to determine the 

service state of the port.  If the service state indicates that the port is 
active, then it is unavailable for certain tests.  Wait until the port is idle 
before retesting.

2. Retry the command at 1-minute intervals up to 5 times.

1001

ABRT

System resources required to run this test were not available.  This could 
be due to a failure to seize the port.

1. Retry the command at 1-minute intervals up to 5 times.

1002

ABRT

The system could not allocate time slots for the test.  The system may be 
under heavy traffic conditions or it may have time slots out-of-service due 
to TDM-BUS errors.

1. If the system has no TDM-BUS errors and is not handling heavy traffic, 

retry the command at 1-minute intervals up to 5 times.

1004

ABRT

The port was seized by a user for a valid call.  

1. Use display port location to determine the trunk group/member 

number of the port.  Use status trunk to determine the service state 

of the port.  If the service state indicates that the port is active, then it is 
unavailable for certain tests.  Wait until the port is idle before retesting.

2. If the port status is idle, retry the command at 1-minute intervals up to 5 

times.

1005

ABRT

Trunk has been administered as incoming-only; dial tone can only be 

obtained on outgoing trunks.  This is a normal condition.

1018

ABRT

Test has been disabled by administration.

1. Verify that the Maintenance Tests field on the Trunk Group form is 

set to n. To enable the test, use change trunk-group x where <x> 

equals the number of the trunk group to be tested.  Enter y in the 
Maintenance Tests field.

2000

ABRT

Response to the test was not received within the allowable time period.

1. Retry the command at 1-minute intervals up to 5 times.

 2 of 4