Cisco Cisco Unified MeetingPlace Audio Server Maintenance Manual
5-9
Cisco MeetingPlace Audio Server 5.2 Customer Engineering Guide (for Cisco MeetingPlace 8106)
78-16411-01
Chapter 5 Repairing and Maintaining the 8106 Server
Replacing the fan assembly
Step 3
Tighten the screw on the left side of the power supply unit.
Note
If you are replacing both power supply units at the same time, follow the above procedure for
each power supply unit. Once they have both been replaced, attach the power cable to the back
of the server and power up the server. Refer to the
each power supply unit. Once they have both been replaced, attach the power cable to the back
of the server and power up the server. Refer to the
.
Step 4
Test that the power supply unit is correctly installed. See the
Replacing the fan assembly
This section describes how to replace the fan assembly.
Warning
When removing the fan tray, keep your hands and fingers away from the spinning fan blades. Let the
fan blades completely stop before you remove the fan tray. Statement 258
fan blades completely stop before you remove the fan tray. Statement 258
Removing the old fan assembly
Step 1
Verify there is no user activity and back up the database. Refer to the
and
.
Step 2
Power down MeetingPlace by following the procedure in the
.
Step 3
Wait 10 seconds before starting to remove the fan assembly. This gives the fan blades time to stop
rotating.
rotating.
Step 4
Manually loosen the three screws on the top, middle, and bottom left side of the fan assembly. No
screwdriver is necessary.
screwdriver is necessary.
Step 5
Pull out the fan assembly. See
.