Cisco Cisco Unified MeetingPlace Audio Server Maintenance Manual
5-7
Cisco MeetingPlace Audio Server 5.2 Customer Engineering Guide (for Cisco MeetingPlace 8106)
78-16411-01
Chapter 5 Repairing and Maintaining the 8106 Server
Replacing the floppy drive and CD-ROM drive card
Replacing the floppy drive and CD-ROM drive card
The floppy drive and CD-ROM drive are housed in the same card. You cannot replace them separately,
as they are connected. If you need to replace one, you automatically replace the other. This section
describes how to replace a floppy drive and a CD-ROM drive card.
as they are connected. If you need to replace one, you automatically replace the other. This section
describes how to replace a floppy drive and a CD-ROM drive card.
Figure 5-7
8106 Server’s Floppy Drive and CD-ROM Drive Card
Note
The floppy drive and CD-ROM drive card is on the front of the server. It has no corresponding transition
module.
module.
Removing the old floppy drive and CD-ROM drive card
Step 1
Verify that all steps in the
have been completed.
Step 2
Identify where the floppy drive and CD-ROM drive card is located. It is always in the front of the server
in the bottom slot. See
in the bottom slot. See
Step 3
Using a screwdriver, loosen the two outer screws on the right and left sides of the floppy drive and
CD-ROM drive card. See
CD-ROM drive card. See
.
Step 4
Pull the floppy drive and CD-ROM drive card straight out of the chassis.
Installing the new floppy drive and CD-ROM drive card
Step 1
Insert the floppy drive and CD-ROM drive card into the empty slot.
Step 2
Tighten the screws on the right and left sides of the floppy drive and CD-ROM drive card.
Step 3
Attach the power cable to the back of the server.