Cisco Cisco ONS 15600 SDH Multiservice Provisioning Platform (MSPP) Guia Da Instalação

If you are not using Simple Network Time Protocol (SNTP), the upgrade procedure can cause the date 
and time setting to change. If you are using SNTP, you do not need to perform this task.

Start CTC.

In node view, click the Provisioning tab, and click the General button.

Set the correct date and time, then click the Apply button. 

Repeat Steps 

 for each remaining node.

Return to your originating procedure (NTP).

If the version in both the Working Version and the Protect Version fields in CTC is Software R9.0, as 
you cannot revert to a previous software version.

The tasks to downgrade to a previous load are not a part of the upgrade. They are provided here as a 
convenience to those wishing to restore an earlier software load after an upgrade. If you have performed 
all necessary procedures up to this point, you have finished the software upgrade.

This task resets the date and time at each node.

PC or UNIX workstation

Prerequisite Procedures None

As needed

Onsite or remote (but in the presence of the workstation)

Superuser

This procedure returns the node to the software and database provisioning 
you had before you activated Software R9.0.

PC or UNIX workstation

As needed

Onsite or remote (but in the presence of the workstation)

Superuser