Cisco Cisco Unified IP Interactive Voice Response (IVR) 8.0(1) Installationsanleitung
7-17
Cisco Customer Response Solutions Installation Guide, Release 6.0(1)
Chapter 7 Upgrading Cisco CRS 3.5(x) to Cisco CRS 6.0
Installing Cisco Unified Communications Manager
Step 5
To prevent the Internet Explorer pop-up blocker from interfering with Cisco CRS,
take these actions to add host names or IP addresses of each server in the
Cisco CRS cluster and in the Cisco Unified Communications Manager cluster to
the Internet Explorer trusted zone:
take these actions to add host names or IP addresses of each server in the
Cisco CRS cluster and in the Cisco Unified Communications Manager cluster to
the Internet Explorer trusted zone:
a.
From Internet Explorer, choose Tools > Pop-up Blocker > Pop-up Blocker
Settings.
Settings.
b.
Enter a host name or an IP address in the Address of Web site to allow field.
c.
Click Add.
Step 6
Repeat
through
for each server in the Cisco CRS cluster.
Step 7
Install BARS on the server on which you will install Cisco Unified
Communications Manager server and configure this sever as a BARS Backup
Server.
Communications Manager server and configure this sever as a BARS Backup
Server.
Step 8
If Cisco Unified Communications Manager and Cisco CRS will be installed on
separate servers, install BARS on each server which you will install the Cisco
CRS Engine component and configure each server as a BARS Backup Target.
separate servers, install BARS on each server which you will install the Cisco
CRS Engine component and configure each server as a BARS Backup Target.
Step 9
Verify hardware settings and network connectivity as described in the
Now you are ready to install Cisco Unified Communications Manager. See the
.
Installing Cisco Unified Communications Manager
After re-imaging the Cisco CRS servers, reinstall Cisco Unified Communications
Manager.
Manager.
When you install Cisco Unified Communications Manager, make sure to specify
the location of the Cisco Unified Communications Manager backup that you
saved as described in the
the location of the Cisco Unified Communications Manager backup that you
saved as described in the
When you complete the installation, make sure that the LDAP is active.
For additional information and instructions, refer to the Cisco Unified
Communications Manager documentation, which is available at this URL:
Communications Manager documentation, which is available at this URL: