Cisco Cisco Unified MeetingPlace Audio Server Maintenance Manual
5-6
Cisco MeetingPlace Audio Server 5.2 Customer Engineering Guide (for Cisco MeetingPlace 8106)
78-16411-01
Chapter 5 Repairing and Maintaining the 8106 Server
Replacing a disk drive
Removing an old disk drive
Step 1
Verify that all steps in the
have been completed.
Step 2
Identify which disk drive you are replacing. See
Figure 5-6
8106 Server’s Hardware Components
Step 3
Using a screwdriver, loosen the screw on the left side of the disk drive.
Step 4
On the right side of the disk drive, push the red button while pulling the black handle towards you.
Step 5
Slide the disk drive straight out of the bay.
Installing a new disk drive
Step 1
Ensure the system is powered down. If you are installing a new disk drive immediately after removing
an old one, the system should still be powered down. Otherwise, follow the steps in the
an old one, the system should still be powered down. Otherwise, follow the steps in the
.
Step 2
Slide the new disk drive straight into the empty drive bay. You hear a click when it is completely in.
Step 3
Secure the disk drive by pushing in the black handle on the right side.
Step 4
Tighten the screw on the left side of the disk drive.
Step 5
Attach the power cable to the back of the server.
Step 6
Power up the server. Refer to the
Step 7
Test that the new disk drive is correctly installed. See the
for more information.