Honeywell International Inc. WFSRM Manuale Utente

18

SWIFT™ Smart Wireless Integrated Fire Technology Manual — P/N LS10036-000NF-E:C 5/8/2015

FWSG FlashScan Wireless System Gateway

1. Start with the gateway powered off. The profile creation process is performed during start-up. 
2. Power on the gateway using SLC power or external +24V. Refer to Sections 2.7.3 and 2.7.4 for 

more information.

3. Ensure that the gateway is in the factory default state. If the gateway is in the factory default 

state, both the LEDs on the gateway will double blink red every second for ten seconds. If the 
LEDs are yellow, refer to “Remove a Profile” on page 18.

4. Activate either magnetic sensor with a magnet within ten seconds of starting up the gateway 

while the double red blink is active on the gateway. Refer to Section 2.4, “Magnet Sensors” for 
further information on activating magnetic sensors. The LED next to the magnetic sensor emits 
a red light for one second when it is activated.  If the ten second window is missed, power 
down the gateway and repeat the process starting at step 1.

A profile has been created successfully; the LEDs on the gateway will light green and stay on 
steady for ten seconds. The profile has been created containing a mesh ID and a default password. 
The default password is ‘12345’ and is needed if the gateway is locked by the FACP and later 
accessed by SWIFT Tools.

Immediately after successful profile creation, the gateway starts the profile distribution mode. 
Refer to Section 2.8.3 for further information on profile distribution mode.

Instead of creating a new profile, an existing profile can be distributed by a device with an existing 
profile. To distribute the existing profile:

1. Ensure that the gateway or other mesh device with the profile is set for distribution. Refer to 

Section 2.8.3, “Profile Distribution” or Section 3.5.2, “Distributor Mode”.

2. Bring the profile distributor within 20 feet of the gateway.
3. 10 seconds after the initial start-up, the LEDs on the gateway switch from a double red blink to 

a single red blink. The single red blink indicated the gateway is ready.

4. Use a magnet to activate either of the magnetic sensors. The LED will blink a single red every 

half-second indicating that it is searching for a profile.

When the profile is successfully received from the distributor, the LEDs on the gateway will turn 
on green steady for five seconds. 

To remove a profile from a gateway:

1. Start with the gateway powered off. The process is performed during start-up.
2. Power on the gateway using SLC power or external +24V.  Refer to Sections 2.7.3 and 2.7.4 

for more information.

3. Verify the gateway is in the profile modification state. The gateway is in the profile 

modification state when both the LEDs on the gateway double blink yellow every second for 
ten seconds.

4. Activate both magnetic sensors on the gateway within ten seconds of start-up while the double 

yellow blink is active. If the ten second window is missed, power down the gateway and repeat 
the process starting at step 1.

The LEDs on the gateway will blink green every second for five seconds indicating that the profile 
is removed.

The gateway communicates with all devices in range that have a common profile and establishes 
communication links with all the devices. This creates a mesh network. Once a device joins the 
mesh, that device acts as a repeater for devices out of the range of the gateway. All devices must be